Fault codes

Common Engine Fault Codes Explained: P0420, P0300, P0171, P0401 and P2002

A fault code tells you which system noticed a problem, not which part failed. Here’s what five common generic engine codes mean, what usually causes them, and what we check before recommending a repair.

These are generic codes, so they mean the same on every make. “Bank 1” is the side of the engine with cylinder 1; four-cylinder engines only have one bank.

P0420: catalyst efficiency below threshold (bank 1)

What it means: the oxygen sensor after the catalytic converter is seeing readings that suggest the converter isn’t cleaning the exhaust as well as it should.

Common causes: a worn catalytic converter, but also a faulty downstream oxygen sensor, an exhaust leak near the sensors, or an engine problem such as misfiring or burning oil that has damaged the converter.

Safe to drive? Usually in the short term, if the car drives normally. But the engine light means an MOT fail on most cars, and if a misfire caused it, that needs fixing quickly.

What we check: sensor readings, exhaust leaks and engine health, before anyone suggests a new catalytic converter, which is an expensive part to fit on a guess.

P0300: random or multiple cylinder misfire

What it means: the engine has detected misfires that aren’t limited to one cylinder. Codes P0301 to P0308 point to a specific cylinder.

Common causes: worn spark plugs or ignition coils on petrol engines, vacuum or intake air leaks, fuelling problems, injector faults, or low compression.

Safe to drive? If the engine light is flashing, no: a heavy misfire can quickly overheat and damage the catalytic converter. Ease off and get it checked.

What we check: misfire counts for each cylinder in live data, ignition and fuelling components, and air leaks, to find out why the misfire happens and when.

P0171: system too lean (bank 1)

What it means: the engine is getting more air, or less fuel, than the computer expects, and it has run out of room to correct it.

Common causes: a split or loose intake hose or vacuum pipe, a dirty or faulty mass airflow sensor, a weak fuel pump or low fuel pressure, a blocked fuel filter or injector, or an exhaust leak ahead of the oxygen sensor.

Safe to drive? Usually for short trips, but a lean engine can hesitate, misfire and run hotter than it should, so don’t leave it.

What we check: fuel trims and airflow readings in live data, then the intake for air leaks and the fuel supply for pressure.

P0401: EGR flow insufficient

What it means: the exhaust gas recirculation system, which feeds some exhaust back into the engine to cut emissions, isn’t flowing as much as it should.

Common causes: carbon build-up in the EGR valve or its passages, especially on diesels, a sticking or failed EGR valve, or a faulty sensor, vacuum line or control solenoid.

Safe to drive? Usually, though you may notice rough running or a loss of power. On diesels, EGR problems can lead to more soot and a blocked DPF.

What we check: whether the valve responds when commanded, the related sensor readings, and the valve and passages for carbon.

P2002: DPF efficiency below threshold (bank 1)

What it means: the readings from the DPF pressure sensor suggest the filter isn’t trapping soot the way it should.

Common causes: a faulty differential pressure sensor, a split, blocked or swapped sensor pipe, an exhaust leak, or a cracked or damaged filter.

Safe to drive? Usually in the short term, but the car may limit power, and visible smoke from a car fitted with a DPF fails the MOT.

What we check: the pressure sensor and its pipes first, as they’re far cheaper than a new filter, then the filter itself. There’s more in our DPF guide.

Why the code isn’t the answer

Every code above has several possible causes, and some of them are cheap. Fitting the most expensive part named in an online search is how drivers end up with a new catalytic converter and the same light on. A proper diagnosis confirms the cause first. See what a diagnostic check shows.