Electrical

Car Battery Flat Overnight? How a Parasitic Drain Is Found

If your car starts fine after a drive but is flat after a night or a few days parked, something is probably drawing power after you lock it. That’s called a parasitic drain. It’s a common electrical fault, and one that’s often misdiagnosed as a bad battery.

Some drain is normal

A parked modern car never fully switches off. The alarm, keyless entry, clock and connected services keep drawing a little power. After you lock up, the car’s modules go to sleep one by one, and the draw drops to a small figure, usually a few tens of milliamps. That can take a while: some cars take more than half an hour to settle.

How much drain is too much?

It doesn’t take much. A fault that draws half an amp removes about 12 amp-hours a day, enough to stop a typical 60 to 70 amp-hour battery starting the car within a few days. A bigger drain, or a battery that’s already weak or not fully charged, can leave you stuck after a single night, especially in cold weather.

Common culprits

  • Hardwired dashcams with parking mode, trackers and aftermarket alarms
  • Aftermarket stereos, amplifiers or lighting wired to a permanent feed
  • A boot, glovebox or interior light that stays on
  • A faulty door, bonnet or boot switch that makes the car think it’s open
  • A module that won’t go to sleep, often after a software glitch or water getting in
  • A sticking relay
  • An alternator with a failing diode, which can leak current when parked
  • On some keyless cars, leaving the key close to the car, which can keep waking it up

Rule out the battery and charging first

Before hunting for a drain, it’s worth confirming the battery can hold a charge and the alternator is charging it properly. A worn battery, or a car that only does short trips, can look exactly like a drain. If the charging system is the problem, see our guide to batteries not charging.

How a drain is traced

  1. Measure the draw. An ammeter or clamp meter on the battery cable shows how much current the car uses while parked.
  2. Let the car go to sleep. The reading only means something once the modules have shut down, so this takes patience. Opening a door, or even reconnecting the battery, can wake everything up and restart the clock.
  3. Find the circuit. Measuring the tiny voltage drop across each fuse shows which ones are passing current, without pulling fuses and waking the car.
  4. Find the component. Once the circuit is known, wiring diagrams and diagnostic data narrow it down to the part or wire responsible.

Things you can check yourself

  • Look for any light that stays on in the boot, glovebox or cabin after locking
  • Think about what’s been fitted or changed recently, such as a dashcam, tracker or new battery
  • Check that the car locks properly and doesn’t show a door, boot or bonnet as open
  • Note how long the car can sit before it won’t start. It helps us estimate the size of the drain