Diagnostics

Garage Couldn’t Find the Fault? How Intermittent Faults Get Diagnosed

“No fault found” is one of the most frustrating things to hear about a car that clearly has a fault. Intermittent problems are hard to diagnose because they’re often not happening when someone is looking. They can be found, though, and there’s a lot you can do to help.

Why intermittent faults get missed

  • The fault isn’t there during the check. If it only happens when the engine is hot, in the rain or over a bump, a quick test on a dry, cold car won’t see it.
  • The codes have been cleared. Clearing codes, or on some cars disconnecting the battery, wipes the stored information that shows when the fault happened.
  • The test was too short. Many fixed-price checks cover a set time, often 30 minutes. Intermittent faults rarely show up to order.
  • Parts were swapped instead of tested. If a part was replaced and the fault went away for a while, it can look fixed when it isn’t.

How you can help

  • Write down when it happens: engine cold or hot, the weather, speed, over bumps, after rain, or at a particular time of day
  • Take a photo or video of the dashboard, or of the noise or behaviour, when it happens, if it’s safe to
  • Don’t clear the codes or disconnect the battery before the visit
  • Keep previous invoices and reports, including anything already replaced
  • Mention recent work, such as accident repairs, a new battery, accessories or a new windscreen. Faults often start after something has been disturbed

How intermittent faults are tracked down

  • Reading the history, not just current faults. Stored codes, freeze-frame data and fault counters show when the problem happened and under what conditions.
  • Recreating the conditions. Testing with the engine hot, under load, or after the car has sat in the wet.
  • Logging data on a drive. Recording sensor readings while the car is driven catches the moment something drops out.
  • Wiggle tests. Moving harnesses and connectors while watching live data, to find a poor connection.
  • Voltage-drop testing. Finding corroded earths and high-resistance connections that look fine but can’t carry current under load.
  • Checking known faults. Many models have well-known weak spots, and knowing them can save hours.

The usual suspects

Most intermittent faults come down to a handful of causes: corroded or loose connectors, chafed wiring where a harness moves or rubs, poor earth connections, water getting into connectors or modules, sensors that fail when hot, and relays that stick.

Already been to a garage?

That’s fine. Tell us what was checked and what was replaced, and we’ll pick up from there rather than starting from scratch. Being mobile helps too: we can test the car where the fault happens, on your drive or at your workplace, rather than after it’s been driven to a garage and cooled down.